Yaskawa Ladder Works Operation Manual - Manual (Page 168)

8. LADDER CONVERSION TOOL
8-2
8.1.1 Start Ladder Conversion Tool
Start the ladder conversion tool from the file manager.
1.
Move the cursor to the PLC folder shown with × mark that shows it was made in the
original ladder editor.
2.
Select Tool (T) - Ladder Converter Tool (L).
3.
The ladder conversion tool is displayed.
Notes:
1. The ladder conversion tool is displayed by right-click menu or pop-up menu.
2. The menu for the ladder conversion tool is not displayed when the cursor is not on
a PLC folder that was made in the original ladder editor.
8.1.2 Ladder Conversion Tool