Yaskawa Ladder Works Operation Manual - Manual (Page 42)

2.5 BRANCH OPERATION
2-25
4.
Move the cursor to the end point of the branch.
5.
The new branch is displayed when the Enter key is pressed.
Notes: Normal edit mode is selected by the Ctrl + U.
2.5.3 Edit Branch
Changing the branch by shortcut key operation is explained. The junction or the joint of the
selected branch is changed to the other position.
1.
Input the Ctrl + E from the keyboard. The branch edit mode icon on the toolbar becomes
active .
Notes: The branch edit mode mouse pointer is displayed.
2.
Move the cursor to the changed point on the branch, and press the Enter key. It can be
changed to other point.