Yaskawa SmartTrac Fault Tables - Manual (Page 41)

10/17/00
New Berlin
Technology Center
Smart Trac
Product Development
Design Document
Faults.doc
Rev. # 19 Page 40 of 64
Title: Fault Declarations
The information contained in this document is the CONFIDENTIAL property of MagneTek Inc.
File = N:\PROJECT\515\SmartTrac\DOCS\Faults.DOC Print Date: 10/17/00
40
Displayed Fault
No.
Priority D
is
p
lay?
Newest
List
?
Ol
d
es
t
List
?
Severity
Assig
n
Program
Input
Corrective Action
Control
Node
Monitor
Fault
Manager
In
ternal Fault
No
.
Fault Legend Description
17537 95543 30007 DC Bus Overvolt OV – Overvoltage. Detection levels:
400VDC for 230V rated unit;
800VDC for 460V rated unit;
1050VDC for 600V rated unit. Yes Yes Yes Minor Major Check input AC supply. Possibility
of erroneous operation due to noise:
remove noise source by connecting
surge suppressor to relay and
magnetic contactor coils; provide line
filter to remove noise on input power
line. If OV trip occurs during
deceleration, increase deceleration
time; may need dynamic braking
option. Note: fault is declared only if
drive is in Run mode.
17538 95544 30008 Heatsnk Overtemp OH – Cooling fin overheat.
Heatsink fin temperature exceeded
preset value found in inverter
parameter L8-02. Yes Yes Yes Minor Minor Major fault declared only if inverter
parameter L8-03
≠
3. Reduce
ambient temperature to less than
45˚C (113˚ F). Clean heat sink.
Replace cooling fan if necessary.
17539 95545 30009 Heatsnk MAX
Temp OH1 – Drive overheat. Heatsink fin
temperature exceeded 105˚ C (221˚
F). Yes Yes Yes Minor Major Reduce ambient temperature to less
than 45˚C (113˚ F). Clean heat sink.
Replace cooling fan if necessary.