PLANET WGSW-50040 - Manual (Page 121)

13-8
no set {ip dscp | ip precedence|internal
priority | drop precedence |cos }
Single bucket mode:
policy <bits_per_second>
<normal_burst_bytes> ({conform-action
ACTION}| exceed-action ACTION} )
Dual bucket mode:
policy <bits_per_second>
<normal_burst_bytes> [pir <peak_rate_bps>]
| <maximum_burst_bytes>
[{conform-action ACTION | exceed-action
ACTION | violate-action ACTION }]
ACTION definition:
drop | transmit | set-dscp-transmit
<dscp_value> | set-prec-transmit
<ip_precedence_value> | set-cos-transmit
<cos_value> | set-internal-priority
<inp_value> | set-Drop-Precedence
<dp_value>
no policy
Configure a policy for the classified flow.
The non-aggregation policy command
supports three colors. Analyze the
working mode of the token bucket,
whether it is singe rate single bucket,
single rate dual bucket, dual rate dual
bucket, set corresponding action to
different color packets. The no
command will delete the mode
configuration. Single bucket mode is
supported by the specific switch.
policy aggregate <aggregate-policy-name>
no policy aggregate
<aggregate-policy-name>
Apply a policy set to classified traffic; the
no command deletes the specified
policy set.
accounting
no accounting
Set statistic function for the classified
traffic. After enable this function under
the policy class map mode, add statistic
function to the traffic of the policy class
map. In single bucket mode, the
messages can only red or green when
passing police. In the print information,
in-profile means green and out-profile
means red. In dual bucket mode, there
are three colors of messages. In the
print information, in-profile means green
and out-profile means red and yellow.
3. Apply QoS to port or VLAN interface
Command Explanation
Interface Configuration Mode
mls qos trust {cos | dscp}
no mls qos trust {cos | dscp}
Configure port trust; the no command
disables the current trust status of the