PLANET WGSW-50040 - Manual (Page 56)

4-18

Running configuration file: refers to the running configuration sequence use in the switch. In
switch, the running configuration file stores in the RAM. In the current version, the running
configuration sequence running-config can be saved from the RAM to FLASH by write command
or copy running-config startup-config command, so that the running configuration sequence
becomes the start up configuration file, which is called configuration save. To prevent illicit file
upload and easier configuration, switch mandates the name of running configuration file to be
running-config.

Factory configuration file: The configuration file shipped with switch in the name of factory-config.
Run set default and write, and restart the switch, factory configuration file will be loaded to
overwrite current start up configuration file.
4.5.3.2 FTP/TFTP Configuration
The configurations of switch as FTP and TFTP clients are almost the same, so the configuration procedures
for FTP and TFTP are described together in this manual.
4.5.3.2.1 FTP/TFTP Configuration Task List
1. FTP/TFTP client configuration
（1） Upload/download the configuration file or system file.
（2） For FTP client, server file list can be checked.
2. FTP server configuration
（1） Start FTP server
（2） Configure FTP login username and password
（3） Modify FTP server connection idle time
（4） Shut down FTP server
3. TFTP server configuration
（1） Start TFTP server
（2） Configure TFTP server connection idle time
（3） Configure retransmission times before timeout for packets without acknowledgement
（4） Shut down TFTP server
1. FTP/TFTP client configuration
（1）FTP/TFTP client upload/download file
Command Explanation
Admin Mode
copy <source-url> <destination-url>
[ascii | binary]
FTP/TFTP client upload/download file.
（2）For FTP client, server file list can be checked.
Admin Mode