PLANET WGSW-50040 - Manual (Page 91)

10-12
no need of added frame label to identify the VLAN which reduce the network traffic.
10.4.2 Dynamic VLAN Configuration
Dynamic VLAN Configuration Task Sequence:
1. Configure the MAC-based VLAN function on the port
2. Set the VLAN to MAC VLAN
3. Configure the correspondence between the MAC address and the VLAN
4. Configure the IP-subnet-based VLAN function on the port
5. Configure the correspondence between the IP subnet and the VLAN
6. Configure the correspondence between the Protocols and the VLAN
7. Adjust the priority of the dynamic VLAN
1. Configure the MAC-based VLAN function on the port
Command Explanation
Port Mode
switchport mac-vlan enable
no switchport mac-vlan enable
Enable/disable the MAC-based VLAN
function on the port.
2. Set the VLAN to MAC VLAN
Command Explanation
Global Mode
mac-vlan vlan <vlan-id>
no mac-vlan
Configure the specified VLAN to MAC
VLAN; the “no mac-vlan” command
cancels the MAC VLAN configuration of
this VLAN.
3. Configure the correspondence between the MAC address and the VLAN
Command Explanation
Global Mode
mac-vlan mac <mac-addrss> vlan
<vlan-id> priority <priority-id>
no mac-vlan {mac <mac-addrss>|all}
Add/delete the correspondence between
the MAC address and the VLAN, namely
specified MAC address join/leave
specified VLAN.
4. Configure the IP-subnet-based VLAN function on the port
Command Explanation
Port Mode
switchport subnet-vlan enable
no switchport subnet-vlan enable
Enable/disable the port IP-subnet-base
VLAN function on the port.