PLANET WGSW-50040 User Manual
Page 218
26-2
3. Configure the timeout value of querying dynamic MAC
4. Display and debug the relative information of number limitation of MAC on ports
1. Enable the number limitation function of MAC、IP on ports
Command
Explanation
Port configuration mode
switchport mac-address dynamic
maximum <value>
no switchport mac-address dynamic
maximum
Enable and disable the number limitation
function of MAC on the ports.
2. Enable the number limitation function of MAC、IP in VLAN
Command
Explanation
VLAN configuration mode
vlan mac-address dynamic maximum
<value>
no vlan mac-address dynamic
maximum
Enable and disable the number limitation
function of MAC in the VLAN.
3. Configure the timeout value of querying dynamic MAC.
Command
Explanation
Global configuration mode
mac-address query timeout <seconds>
Configure the timeout value of querying
dynamic MAC.
4.Display and debug the relative information of number limitation of MAC on ports
Command
Explanation
Admin mode
show mac-address dynamic count {vlan
<vlan-id>|interface ethernet
<portName> }
Display the number of dynamic MAC in
corresponding ports and VLAN.
debug switchport mac count
no debug switchport mac count
All kinds of debug information when
limiting the number of MAC on ports.
debug vlan mac count
no debug vlan mac count
All kinds of debug information when
limiting the number of MAC in VLAN.