PLANET WGSW-50040 - Manual (Page 76)

8-3
<port-channel-number>
8.3 Port Channel Examples
Scenario 1: Configuring Port Channel in LACP.
Figure 8-2 Configuring Port Channel in LACP
The switches in the description below are all switch and as shown in the figure, ports 1, 2, 3, 4 of SwitchA are
access ports that belong to VLAN1. Add those four ports to group1 in active mode. Ports 6, 8, 9, 10 of SwitchB
are access ports that also belong to VLAN1. Add these four ports to group2 in passive mode. All the ports
should be connected with cables.
The configuration steps are listed below:
SwitchA#config
SwitchA (config)#interface ethernet 1/1-4
SwitchA (Config-If-Port-Range)#port-group 1 mode active
SwitchA (Config-If-Port-Range)#exit
SwitchA (config)#interface port-channel 1
SwitchA (Config-If-Port-Channel1)#
SwitchB#config
SwitchB (config)#port-group 2
SwitchB (config)#interface ethernet 1/6
SwitchB (Config-If-Ethernet1/6)#port-group 2 mode passive
SwitchB (Config-If-Ethernet1/6)#exit
SwitchB (config)#interface ethernet 1/8-10
SwitchB (Config-If-Port-Range)#port-group 2 mode passive
SwitchB (Config-If-Port-Range)#exit
SwitchB (config)#interface port-channel 2
SwitchB (Config-If-Port-Channel2)#
SwitchA
SwitchB