PLANET WGSW-50040 - Manual (Page 27)

3-10
3) In the “Connecting using” drop-list, select the RS-232 serial port used by the PC, e.g. COM1, and click
“OK”.
Figure 3-4 Opening HyperTerminal
4) COM1 property appears, select “9600” for “Baud rate”, “8” for “Data bits”, “none” for “Parity checksum”, “1”
for stop bit and “none” for traffic control; or, you can also click “Restore default” and click “OK”.
Figure 3-5 Opening HyperTerminal