Panasonic TH-55VF2HW 54.6" Full HD Video Wall Display - Manual (Page 12)

English
12
Notes on Using Wired LAN
When setting up the Display at a place, where
electric statistic occurs often, take a sufficient anti-
static measure before start using.
• When the Display is used at a location, where static
electricity occurs often, such as on a carpet, a wired
LAN or DIGITAL LINK communication is disconnected
more often. In that case, remove static electricity
and the noise source that may cause problems with
an antistatic mat, and re-connect the wired LAN or
DIGITAL LINK.
• In rare cases, the LAN connection is disabled due
to static electricity or noise. In that case, turn off the
power of the Display and the connected devices once
and then re-turn on the power.
The Display may not work properly due to strong
radio wave from the broadcast station or the radio.
• If there is any facility or equipment, which outputs
strong radio wave, near the installation location, set
up the Display at a location sufficiently far from the
source of the radio wave. Or, wrap the LAN cable
connected to the DIGITAL LINK / LAN terminal by
using a piece of metal foil or a metal pipe, of which is
grounded at both ends.
Request Regarding Security
When using this unit, take safety measures against
the following incidents.
• Personal information being leaked via this unit
• Unauthorized operation of this unit by a malicious
third party
• Interfering or stopping of this unit by a malicious third
party
Take sufficient security measures. (see page 91, 95)
• Set a password for the LAN control and restrict the
users who can log in.
• Make your password difficult to guess as much as
possible.
• Change your password periodically.
• Panasonic Corporation or its affiliate companies will
never ask for your password directly. Do not divulge
your password in case you receive such inquiries.
• The connecting network must be secured by a
firewall, etc.
• When disposing the product, initialize the data before
disposing.
([Shipping] (see page 116))
Cleaning and maintenance
The front of the liquid crystal panel has been
specially treated. Wipe the surface of the liquid
crystal panel gently using only a cleaning cloth or a
soft, lint-free cloth.
• If the surface is particularly dirty, wipe with a soft,
lint-free cloth which has been soaked in pure water
or water in which neutral detergent has been diluted
100 times, and then wipe it evenly with a dry cloth of
the same type until the surface is dry.
• Do not scratch or hit the surface of the panel with
fingernails or other hard objects, otherwise the
surface may become damaged. Furthermore, avoid
contact with volatile substances such as insect
sprays, solvents and thinner, otherwise the quality of
the surface may be adversely affected.
If the cabinet becomes dirty, wipe it with a soft, dry
cloth.
• If the cabinet is particularly dirty, soak the cloth in
water to which a small amount of neutral detergent
has been added and then wring the cloth dry. Use this
cloth to wipe the cabinet, and then wipe it dry with a
dry cloth.
• Do not allow any detergent to come into direct contact
with the surface of the Display. If water droplets get
inside the unit, operating problems may result.
• Avoid contact with volatile substances such as insect
sprays, solvents and thinner, otherwise the quality of
the cabinet surface may be adversely affected or the
coating may peel off. Furthermore, do not leave it for
long periods in contact with articles made from rubber
or PVC.
Usage of a chemical cloth
• Do not use a chemical cloth for the panel surface.
• Follow the instructions for the chemical cloth to use it
for the cabinet.
Disposal
When disposing the product, ask your local
authority or dealer about the correct methods of
disposal.