Panasonic TH-55VF2HW 54.6" Full HD Video Wall Display - Manual (Page 29)

29
English
USB terminal connection
Connect the USB memory to use [USB media player].
(see page 99)
USB memory device
Pin assignments and signal names for USB Terminal
1 3 4 2
Pin No. Signal name
+5 V DC
DATA -
DATA +
GND (Ground)
Power of up to 5V/500mA can be supplied to an external
device when the picture is displayed.
● If the electric current exceeding the power supplying
capability is applied, the output is blocked, and the
following message is displayed.
[USB DC5V OUT overload. Please remove cable or
equipment, then turn the display off/on.]
In this case, remove the equipment and then turn the
power off/on using the remote control, etc.
Note
● If the direct connection to this unit is not possible due
to the size of a stick PC, etc. use a commercially sold
extension cable.
● Depending on the type of a USB memory device,
it may come in contact with the periphery such as
a back cover, and cannot be attached. Use a USB
memory device connectable to this unit.
● When connecting the USB memory device, confirm
the orientation of the plug to prevent damage to the
terminal.
● When removing the USB memory device, note the
following.
• When the access indicator of the connected USB
memory device is blinking, it shows the display is
loading the data. Do not remove the USB memory
device while blinking.
• Depending on the USB memory device, the access
indicator may remain blinking even when it is not
being accessed, or the device is not equipped
with an access indicator function, etc. In this case,
remove the USB memory device after confirming
the following or .
Switch the input to an input other than [USB],
and confirm that the functions that access USB
memory device are finished. The functions are,
read user image function (see page 74), data
cloning function (see page 106), etc.
Turn the unit off.
• Do not frequently repeat connecting/disconnecting
the USB memory device. Wait at least 5 seconds
after connection, and then remove the USB
memory device. Before reconnection, wait at least
5 seconds. A certain length of time is required
so that the display can recognise that the USB
memory device is switched for connection or
disconnection.
• If the power of this unit is turned off or the USB
memory device is removed accidentally while
accessing data, the data may not be accessed
next time the USB memory device is used.
In such a case, turn the power of the main unit off
and on.