Panasonic TH-55VF2HW 54.6" Full HD Video Wall Display - Manual (Page 65)

65
English
Input label
This function can change the label of the Input signal to
be displayed.
[Input label] - submenu screen
HDMI
DisplayPort
DIGITAL LINK
PC PC
DIGITAL LINK
DisplayPort
DVI-D1 DVI-D1
DVI-D2 DVI-D2
HDMI
Input label
[HDMI] [HDMI] / [DVD1] / [DVD2] /
[DVD3] / [Blu-ray1] / [Blu-ray2] /
[Blu-ray3] / [CATV] / [VCR] /
[STB] / (Skip)
[DisplayPort] [DisplayPort] / [DVD1] / [DVD2] /
[DVD3] / [Blu-ray1] / [Blu-ray2] /
[Blu-ray3] / [CATV] / [VCR] /
[STB] / (Skip)
[DIGITAL LINK] [DIGITAL LINK] / [DVD1] /
[DVD2] / [DVD3] / [Blu-ray1] /
[Blu-ray2] / [Blu-ray3] / [CATV] /
[VCR] / [STB] / (Skip)
[DVI-D1] [DVI-D1] / [DVD1] / [DVD2] /
[DVD3] / [Blu-ray1] / [Blu-ray2] /
[Blu-ray3] / [CATV] / [VCR] /
[STB] / (Skip)
[DVI-D2] [DVI-D2] / [DVD1] / [DVD2] /
[DVD3] / [Blu-ray1] / [Blu-ray2] /
[Blu-ray3] / [CATV] / [VCR] /
[STB] / (Skip)
[PC] [PC] / [DVD1] / [DVD2] /
[DVD3] / [Blu-ray1] / [Blu-ray2] /
[Blu-ray3] / [CATV] / [VCR] /
[STB] / (Skip)
(Skip): When <INPUT> is pressed, the input will be
skipped.
Power management settings
Set each item to reduce power consumption.
This function works only for the input terminal that is
currently selected.
[Power management settings] - submenu screen
Power management settings
Power management mode
No signal power off
HDMI power management
DVI-D1 power management
PC power management
DVI-D2 power management
Extended standby mode
Custom
Off
Off
Disable
Off
Off
Off
DIGITAL LINK power management Off
To control with the remote control:
Switches [Power management mode] by pressing
<ECO>.
Power management mode On
■
[Power management mode]: [On]
The following fixed values are set to the menu of
power consumption reduction. Individual setting is not
available.
[No signal power off]: [Enable]
[HDMI power management]: [On]
[DIGITAL LINK power management]: [On]
[DVI-D1 power management]: [On]
[DVI-D2 power management]: [On]
[PC power management]: [On]
■
[Power management mode]: [Custom]
The menu of the power consumption reduction is
individually set. This setting is enabled when [Power
management mode] is set to [Custom].
[No signal power off]
When this is set to [Enable], the power supply of the
unit goes off automatically when there is no operation or
sync signal for about 10 minutes.
Note
● With the USB input, the unit determines no signal is
present when the USB memory is not connected to
the USB terminal, or the connected USB memory
does not contain any playable file.
● This function may not operate depending on the video
output devices.