Panasonic TH-55VF2HW 54.6" Full HD Video Wall Display - Manual (Page 54)

English
54
● The operations of the main software version 1.2000
or later are as follows.
• When this function is set to [DIGITAL LINK], set
[Quick start] to [On] to enable the operation.
• When [Quick start] is set to [Off], if this function
is set to [DIGITAL LINK], the unit is controlled via
DIGITAL LINK in power-on state while controlled
with the IR IN terminal in standby state. To enable
the DIGITAL LINK control even in standby state, it
is necessary to set [Quick start] to [On].
■
[IR out]
Sets the terminal used for the IR signal output.
[IR OUT]: IR output terminal
[DIGITAL LINK]: DIGITAL LINK OUT terminal
Note
● The operations of the main software version 1.2000
or later are as follows.
• When this function is set to [DIGITAL LINK], set
[Quick start] to [On] to enable the operation.
• When [Quick start] is set to [Off], if this function
is set to [DIGITAL LINK], the unit outputs to the
DIGITAL LINK OUT terminal in power-on state
while outputs to the IR OUT terminal in standby
state. To output to the DIGITAL LINK terminal even
in standby state, it is necessary to set [Quick start]
to [On].
■
[Serial control]
Sets the terminal used for the serial communication
input.
[SERIAL IN]: Serial terminal
[DIGITAL LINK]: DIGITAL LINK IN terminal
Note
● The operations of the main software version 1.2000
or later are as follows.
• When this function is set to [DIGITAL LINK], set
[Quick start] to [On] to enable the operation.
• When [Quick start] is set to [Off], if this function
is set to [DIGITAL LINK], the unit outputs to the
DIGITAL LINK OUT terminal in power-on state
while outputs to the SERIAL IN terminal in standby
state. To output to the DIGITAL LINK terminal even
in standby state, it is necessary to set [Quick start]
to [On].
■
[Serial out]
Sets the terminal used for the serial communication
output.
[SERIAL OUT]: Serial output terminal
[DIGITAL LINK]: DIGITAL LINK OUT terminal
Note
● The operations of the main software version 1.2000
or later are as follows.
• When this function is set to [DIGITAL LINK], set
[Quick start] to [On] to enable the operation.
• When [Quick start] is set to [Off], if this function
is set to [DIGITAL LINK], the unit outputs to the
DIGITAL LINK terminal in power-on state while
outputs to the SERIAL OUT terminal in standby
state. To output to the DIGITAL LINK terminal even
in standby state, it is necessary to set [Quick start]
to [On].
■
[Display ID]
Set ID number when controlling the Display with
[Controller ID function] and [Serial ID function].
0 to 100 (Standard value: 0)
■
[Controller ID function]
Enables/disables the [Controller ID function].
[Off]:
Disables the [Controller ID function]. (Can be
operated as normal remote control.)
[On]:
Enables the [Controller ID function]. Effective on
switching to [On].
Note
● To use the [Controller ID function], setting ID numbers
both for the remote control and for the display unit is
required.
For ID number setting for the remote control, see
page 112.
● About how to reset the settings to defaults:
“Initialization” (see page 81)
■
[Serial ID function]
Set to control external control with the PC connected to
SERIAL terminal according to the Display’s ID number.
[Off]:
Disables external control by the ID.
[On]:
Enables the external control by the ID.