Control settings, Input signal display, Ir control – Panasonic TH-55VF2HW 54.6" Full HD Video Wall Display User Manual

Page 53

Advertising
background image

53

English

Input signal display

Displays the frequency and the type of the current input

signal.

60.00 Hz
74.18 MHz
1125(1080)/60i

33.72 kHz

H-freq.

V-freq.

Dot clock freq.

Signal format

Display range:

Horizontal (15 kHz - 135 kHz)
Vertical (24 Hz - 120 Hz)

The dot clock frequency is displayed when Digital and

PC signal are input.

Control settings

Sets each item of the function which enables to control

multiple displays at the same time, or individually.
[Control settings] - submenu screen

0

Control settings

IR control

IR out

Serial ID group

Serial control

Serial response(ID group)

Serial response(ID all)

Serial daisy chain position

IR OUT

A

SERIAL IN

Off

Off

Multi control auto setting(DIGITAL LINK)

Serial out

SERIAL OUT

Display ID
Controller ID function

Off

Serial ID function

Off

Serial response (Normal)

On

Built-in

[IR control]

Sets the terminal used for the IR signal input.
The terminal ([Built-in] / [IR IN] / [DIGITAL LINK])

which is currently selected is displayed on the [Control

settings] submenu screen.

Select [IR control] with and press <ENTER>.

On the [IR control] submenu screen, select the terminal

to use.

IR control

IR control

Auto

[IR IN]:

Connecting an external IR receiver or IR cable to

the IR IN terminal will switch to the remote-control

operation via the IR IN terminal. The display is

fixed to [IR IN].
Although the setting can be changed to something

other than [IR IN] while using the IR IN terminal,

the changed setting is invalid.

[Auto]:

Only when connected to the unit via DIGITAL

LINK, signals are received with the DIGITAL LINK

IN terminal. For other connections, remote control

signals are received with the remote control sensor

of the unit.

[Built-in]:

Remote control sensor of the unit

[DIGITAL LINK]:

DIGITAL LINK IN terminal

Note

[IR IN] cannot be set manually.

When [Auto] is set, the unit automatically detects the

connection in power-on status. This setting does not

respond to the connection change in standby mode.

The changed setting is enabled when the [IR control]

sub menu screen is exited.

Advertising