Panasonic TH-55VF2HW 54.6" Full HD Video Wall Display - Manual (Page 18)

English
18
Connections
AC cord connection and fixing
Back of the unit
AC cord fixing
AC cord (supplied)
Plug the connector into the display unit.
Plug the connector until it clicks.
Note
● Make sure that the connector is locked on both the
left and right sides.
Unplug the AC cord
Unplug the connector pressing the two knobs.
Note
● Do not use an AC cord of which the knobs are
damaged. If it is used with the knobs damaged, a
bad connection may result between the AC cord
connector and the AC IN terminal. For the repair of
the AC cord, consult the dealer where you purchased
the product.
● When disconnecting the AC cord, be absolutely sure
to disconnect the AC cord plug at the socket outlet
first.
● The supplied AC cord set is for this unit exclusive use.
Do not use this for other purposes.
Cable fixing
Note
● 3 clampers are supplied with this unit. Fix the cables
at 3 locations using the holes for clampers as shown
below.
If you need more clampers, purchase them from your
dealer. (Available from the customer service)
1. Attach the clamper
Keep pushing both side
snaps and pull out the
clamper.
hole
Insert the clamper in a
hole.
To remove from
the unit:
snaps
2. Bundle the cables
Keep pushing the knob
and pull out the tip.
hooks
Set the tip in the hooks
and tighten.
To loosen:
knob