Canon imagePROGRAF PRO-300 13" Photographic Inkjet Printer - Manual (Page 423)

• When you connect a Wi-Fi Direct compatible device to the printer, select the device name
displayed on the LCD from your device.
• To change the identifier (SSID) and the password, see below.
Changing Wireless Direct Setting
Changing Settings of a Device and Connecting It to the Printer
1. Turn on Wi-Fi function on your device.
Enable "Wi-Fi" on your device's "Setting" menu.
For more on turning on Wi-Fi function, see your device's instruction manual.
2. Select "DIRECT-XXXX-PRO-300 series" ("X" represents alphanumeric characters) from
list displayed on your device.
Note
• If "DIRECT-XXXX-PRO-300 series" does not appear on the list, Wireless Direct is not enabled.
See Changing Printer Setting to Use Wireless Direct to enable Wireless Direct.
3. Enter password.
Your device is connected to the printer.
Note
• Check the password for the Wireless Direct.
1. Select LAN settings on the Home screen and then press the OK button.
2. Select Wireless Direct and then press the OK button.
3. Select Show password and then press the OK button.
• Depending on the device you are using, entering the password is required to connect a device
to the printer via Wi-Fi. Enter the password specified for the printer.
• If your Wi-Fi Direct compatible device is set to prioritize using Wi-Fi Direct and it is connecting
to the printer, the printer displays a confirmation screen asking if you allow the device to
connect to the printer.
Make sure the name on the LCD is the same as that of your wireless communication device
and select
Yes .
Changing Wireless Direct Setting
Change the settings for the Wireless Direct following the procedure below.
1. Select LAN settings on the HOME screen and then press the OK button.
423