Symmetricom EDGE CLOCK 1000 - Manual (Page 136)

Chapter 4 Provisioning the TimeProvider
Provisioning SNMP Parameters
136 TimeProvider User’s Guide 097-58001-02 Revision G – April 2008
This command has a default access level of USER.
Sample Command
OPR-ACO-ALL:::TS1000;
Normal Response
TP-SSU 03-10-24 11:26:47
M TS1000 COMPLD
“IMC,EQPT:NA,ACO,NSA,03-10-24 11-26-47:\"AUDIO ALARM IS
DEACTIVATED”
;
Provisioning SNMP Parameters
The Simple Network Management Protocol (SNMP) implemented in the
TimeProvider supports SNMP v1, v2C, and v3. You can add up to 20 SNMP users
(also known as communities or principals); these users cannot have the same name
as TL1 users.
Activating SNMP
You use the ACT-FEATURE command to enable the SNMP feature on the
TimeProvider. You should contact your Symmetricom Sales representative and
order part number 920-58002-01 to obtain the key to activate the SNMP feature.
ACT-FEATURE:[<tid>]:<fid>:[<ctag>]::<key>;
This command has a default access level of ADMIN.
Sample Command
ACT-FEATURE::SNMP:TS1000::”ABcdEFgh123456”;
This command enables the SNMP feature within the TimeProvider, and uses an
activation code provided by Symmetricom.
Normal Response
TP-SSU 03-05-15 09-59-09
M 1166 COMPLD
“IMC Serial#=ABC123”
“SNMP activated”
;
Parameter <value> Description
<fid> SNMP The feature to be enabled.
<key> Up to 20 case-sensitive characters; must
be within quotes to be case-sensitive. Key to enable the feature