Symmetricom EDGE CLOCK 1000 - Manual (Page 168)

Chapter 6 Maintaining and Troubleshooting the TimeProvider
Troubleshooting the TimeProvider
168 TimeProvider User’s Guide 097-58001-02 Revision G – April 2008
ECHO The current sessions’
echo setting has
changed EQPT DISABLE ENABLE – User’s keystrokes
are echoed
DISABLE – User’s keystrokes
are not echoed
FLOW The IMC serial port
flow control has
changed EQPT NONE NONE – No flow control
SW – Software flow control
(XON/XOFF)
HW – Hardware flow control
(CTS/RTS)
SWHW – Both hardware and
software flow control used
FWFAIL Firmware upgrade of
IMC or IOC was not
successful EQPT n/a n/a
FWOK Firmware upgrade of
IMC or IOC was
successful EQPT n/a n/a
INACTTIME The communication
inactivity timeout has
been set. If no activity
within the specified
time, the session
closes EQPT 0 0 – Disable timeout
100 to 10000 seconds
INITLOG The event log has
been initialized EQPT n/a n/a
IPADDR The IMC Ethernet
address has been
changed EQPT 127.0.0.1 1.0.0.1 to 254.255.255.254
IPGATE The IMC Ethernet
gateway address has
been changed EQPT 127.0.0.1 1.0.0.1 to 254.255.255.254
IPSUB The IMC Ethernet
subnet mask has been
changed EQPT 255.255.255.0 n/a
ISDIFF Indicates that the CRC
of two Istate images
stored on separate
modules are different EQPT n/a n/a
Table 6-5. Event Codes (Continued)
Event ID
Keyword
Description
AID
TYPE
Default Value/
Keyword
Description of Values