Symmetricom EDGE CLOCK 1000 - Manual (Page 186)

Chapter 6 Maintaining and Troubleshooting the TimeProvider
Troubleshooting the TimeProvider
186 TimeProvider User’s Guide 097-58001-02 Revision G – April 2008
RQLEVEL Received quality level has changed <value>
QLEVEL Quality Level has changed <value>
SSMBIT E1 SSM bit has changed <bit position>
SSENA Input reading of SSM has changed <value>
MTIE-1 MTIE 1-second threshold has been exceeded
MTIE-5 MTIE 5-second threshold has been exceeded
MTIE-10 MTIE 10-second threshold has been exceeded
MTIE-50 MTIE 50-second threshold has been exceeded
MTIE-100 MTIE 100-second threshold has been exceeded
MTIE-500 MTIE 500-second threshold has been exceeded
IOC Output Events
FRMTYPE Output framing type has changed <value>
FREEFLT Free-run output fault strategy has changed <value>
HOLDFLT Holdover output fault strategy has changed <state>
OUTSTATE Output group state has changed <value>
SYS Events
CLRDELAY Input clear delay has changed <value>
ELEVTIME Alarm elevation time has changed <state>
FACTORY Provisioned to factory defaults
FLTDELAY Input fault delay has changed <value>
GPSCLRDEL GPS fault delay has changed <value>
GPSFLTDEL GPS fault delay has changed <value>
INPREF System reference input has changed <value>
LOCTIM System’s local time offset has changed <time offset>
REFMODE System reference mode has changed <mode>
TIMCHG System time has changed <time>
UTC UTC time has been set by GPS <time>
Table 6-8. Conditions Causing an Event (Continued)
Event ID Condition