Symmetricom EDGE CLOCK 1000 - Manual (Page 138)

Chapter 4 Provisioning the TimeProvider
System Commands
138 TimeProvider User’s Guide 097-58001-02 Revision G – April 2008
SNMP v3
To set up Notifications, create an SNMP v3 user with or without MD5 or SHA using
the ENT-USER-SECU command. DO not add the engineid. Add a MGRx and
SENDERx using the ED-EQPT command. Set the IFTOUTx and IFRETRYx
parameters to 0.
To set up Informs, create an SNMP v3 user with or without MD5 or SHA using the
ENT-USER-SECU command. Include the engineid of the manager engine. Add a
MGRx and SENDERx using the ED-EQPT command. Set the IFTOUTx and
IFRETRYx parameters to a nonzero value.
System Commands
This section describes the TL1 commands you use to perform the following routine
operations with the TimeProvider:
Displaying events
Displaying the current configuration
Restarting the TimeProvider
Displaying Events
The RTRV-LOG command displays all the events in the event log in chronological
order (first in - first out). The event log contains the 500 most recent alarmed and
non-alarmed events. Alarms with an alarm level of NONE are not stored in the log.
RTRV-LOG:[<tid>]:[<aid>]:[<ctag>][::<keyword>=<value>];
This command has a default access level of USER.
Sample Command
RTRV-LOG::INP1:TS1000::ALM;
This command causes the TimeProvider to return all alarms stored in the log for
Input 1.
<aid> <keyword> Description
ALL (or null)
IMC
IOC
IOCm (m = 1 | 2)
GPS
PRS
INPp (p = 1 | 2)
OUTg (g = A | B | C | D) All (or null) Displays both events and alarms stored in the
log for the specified aid
EVT Displays events stored in the log for the
specified event
ALM Displays alarms stored in the log for the
specified event