Sharp AR-M162 - Manual (Page 10)

8
INSTALLATION REQUIREMENTS
Improper installation may damage this product. Please note the following during initial installation and whenever the
machine is moved.
1. The machine should be installed near an accessible power outlet for easy connection.
2. Be sure to connect the power cord only to a power outlet that meets the specified voltage and current
requirements. Also make certain the outlet is properly grounded.
• For the power supply requirements, see the name plate on the back of the main unit.
3. Do not install your machine in areas that are:
• damp, humid, or very dusty
• exposed to direct sunlight
• poorly ventilated
• subject to extreme temperature or humidity changes, e.g., near
an air conditioner or heater.
4. Be sure to allow the required space around the machine for
servicing and proper ventilation.
ENVIRONMENTAL INFORMATION
Connect the machine to a power outlet which is not used for other electric appliances. If a lighting fixture is
connected to the same outlet, the light may flicker.
A small amount of ozone is produced within the printer during operation. The emission level is insufficient to cause any health
hazard.
NOTE:
The present recommended long term exposure limit for ozone is 0.1 ppm (0.2 mg/m 3 ) calculated as an 8 hr. time-weighted
average concentration.
However, since the small amount that is emitted may have an objectionable odor, it is advisable to place the copier in a
ventilated area.
As an ENERGY STAR ® Partner, SHARP has determined that this product meets the ENERGY
STAR ® guidelines for energy efficiency.
The Environmental Choice Program guidelines are applied to the products only in Canada. The
products that meet the Environmental Choice Program guidelines carry the logo shown to the left.
The products without the logo may not meet the Environmental Choice Program guidelines.
USB 2.0 compatible (dual function board (AR-EB9))
When connecting the machine by USB 2.0 (Hi-Speed mode), be sure to read "System requirements
for USB 2.0 (Hi-Speed mode)" (see the "Key operator's guide") to verify that your system and the
machine settings are configured appropriately.
Note
8" (20 cm)
8"
(20 cm)
8"
(20 cm)