Sharp AR-M162 - Manual (Page 166)

37
ADVANCED TRANSMISSION METHODS
3
USING THE POLLING FUNCTION
When used in conjunction with the timer transmission function (page 34), only one polling job can be stored.
1 In Fax mode, press the [SPECIAL
FUNCTION] key.
When the [SPECIAL
FUNCTION] key is pressed, the
special function menu appears.
(To select fax mode, see step 1
on page 18.)
2 Select "SENDING OPTIONS" with the
[
] or [ ] key.
3 Press the [OK] key.
4 Select "POLLING" with the [ ] or [ ]
key.
5 Press the [OK] key.
6 Enter the fax number of the other
machine with the numeric keys, press
a Rapid key, or specify a Speed Dial
number (a group key cannot be used).
To clear a mistake when
entering a full number with the
numeric keys, press the [C] key
to clear one digit at a time.
A destination selected with a Rapid key or Speed Dial
number is indicated by an icon and a number. To clear
an entry, press the [C] key.
7 Press the [OK] key.
8 Press the [START] key.
"Polling reservation has been
set." appears in the screen.
After communicating with the
other machine, your machine
prints the received fax.
If the other machine is using polling security (see "Restricting polling access (polling security)" on page 41), your
fax number (sender's number) must be programmed in the key operator programs (see "OWN PASSCODE SET"
on page 96) and your number must also be programmed in the other machine.
Note
2-SIDED
COPY
SPECIAL FUNCTION
ACC.
DUPLEX SCAN
GH
PQR
2-SIDED
COPY
SPECIAL FUNCTION
SPECIAL FUNCTION
FAX PRINT HOLD
TIMER MODE
SENDING OPTIONS
GHI
OK BACK
SENDING OPTIONS
POLLING
SERIAL POLLING
SUB ADDRESS TX
OK
WXYZ
26 27 28 29
31 32 33 34
A B C
F G H
OK
WXYZ
@.-_
READ-END
To cancel the operation
During communication: Cancel as explained in "Cancelling a fax transmission" on page 26.
While the job is stored: Cancel as explained in "Cancelling a stored transmission job" on page 27.
Note