Sharp AR-M162 - Manual (Page 266)

22
HOW TO USE THE NETWORK SCANNER FUNCTION
SELECTING A DESTINATION (USING THE [ADDRESS]
KEY)
A destination can be selected using one of three methods: Selecting from "ADDRESS BOOK", using "ADDRESS
ENTRY", or "ADDRESS SEARCH".
"ADDRESS BOOK"
1 Perform steps 1 to 6 of "BASIC
TRANSMISSION PROCEDURE" (
page 20 ).
2
Press the [ADDRESS] key.
The address selection
screen appears
3 Press the [OK] key.
4 Change tabs as needed with the [ ] or
[ ] key and select the desired
destination with the [ ] or [ ] key.
• The [USER] tab changes as follows each time you
press the [ ] key:
[USER] → [ABCD] → [EFGHI] → [JKLMN] → [OPQRST]
→ [UVWXYZ] → [USER] → [ABCD] → ...
To move backwards through the tabs, press the [ ]
key.
• You can switch between information on the selected
destination and the destination list by pressing the
key.
5 Press the key.
A checkmark appears by the
selected destination. To
cancel the selection, press the
key once again to remove
the checkmark.
To select multiple
destinations, repeat steps 4
and 5.
6 Press the [OK] key.
Multiple destinations can be
selected for a Scan to E-mail
transmission. (Maximum of
20.)
Only one destination can be selected for a Scan to
FTP or Scan to Desktop transmission.
7
Continue from step 9 of "BASIC
TRANSMISSION PROCEDURE" (
page 21 ).
8
OSURE PAPER ZOOM AUTO % OUTP
R MODE
GRAM
RESOLUTION
RESOLUTION ADDRESS FORMAT ORIGINA
ORIGINA ADDRESS BROADCAST
DESTINATION SELECT
ADDRESS BOOK
ADDRESS ENTRY
ADDRESS SEARCH
GHI
OK BACK
USER
PPD
SALES
[#]:LIST DETAIL
[ ]:SELECT ON/OFF
GH
PQR
DUPLEX
SPECIAL FUNCTION
DUPLEX SCAN
USER
PPD
SALES
SUPPORT
[ ]:SELECT ON/OFF
Canceling transmission
• To cancel the transmission while
"Reading" appears or before the key is
pressed, press the [C] or [CA] key.
• If the power is turned off or a power failure
occurs while a document is being
scanned in the SPF, the machine will stop
and a document misfeed will occur. After
the power is restored, remove the
document as explained in "ORIGINAL
MISFEED IN THE SPF" in "Operation
manual (for general information and
copier)".
@.-_ FUNCTION
ACC. #-C READ-E
OK
Note