Sharp AR-M162 - Manual (Page 63)

61
4
TWO-SIDED COPIES USING THE
BYPASS TRAY
Follow the steps below to perform two-sided copying manually.
Example: Copying original A and original B onto both sides of the paper
1 Copy original A.
2
Place original B as shown below.
Vertically-oriented
original:
If the original is oriented
vertically, place it in the
same orientation as
original A.
Horizontally-oriented
original:
Place in the opposite
orientation (rotated 180
degrees) to that of
original A.
3 Turn the copy of original A over, and
without changing the position of the
edge closest to you, insert it in the
bypass tray.
Insert the paper all the
way in.
4 Select the bypass tray with the
[PAPER] key and then press the
[START] key (
).
The copies are delivered to the center tray.
1 2 1
If you are using the AR-M207
The AR-M207 is equipped standard with an
automatic two-sided copying function that
automatically turns over the paper. If paper in
"Paper that can be used for automatic 2-sided
printing" on page 18 is used, this enables easier
two-sided copying than using the bypass tray. See
"TWO-SIDED COPYING" on page 56.
1
1
Original A
Copy of
original A
1
1
Original A
Copy of
original A
2
Original B
2
Original B
• Copies made on the back side of paper
should always be made one sheet at a
time using the bypass tray.
• Straighten curled or wavy paper before
using it. Curled paper may cause
misfeeds, creases, or a poor-quality
image.
2 1 1
Copy of
original A
Original B
2
1 1
Copy of
original A
Original B
Note