Sharp AR-M162 - Manual (Page 37)

35
2
REPLACING THE TONER CARTRIDGE
When the toner replacement icon ( ) appears, little toner remains. Obtain a replacement cartridge as soon as possible.
When the message " Add toner. Can not copy or print." appears in the display, the toner cartridge must be
replaced before copying can be resumed. Follow the steps below to replace the toner cartridge.
1 Open the front cover.
Push gently on both ends of the
front cover to open it.
2 Pull the toner cartridge out while
pressing on the toner cartridge lock
release lever.
When pulling out the toner
cartridge, place one hand on
the green part of the cartridge.
3 Remove the new toner cartridge from
the bag. Grasp the cartridge on both
sides and shake it horizontally four or
five times. After shaking the cartridge,
remove the tape.
4 While pressing down on the toner
cartridge lock release lever, insert the
toner cartridge along the guides all
the way in.
If there is any dirt or dust on the
toner cartridge, remove it before
installing the cartridge.
5 Remove the tape and then pull the
shutter out of the toner cartridge.
Discard the shutter.
6 Close the front cover.
The toner cartridge replacement
required icon (
) will no longer
appear and copying will be
possible.
• During a long copy run or when copying originals with many dark areas, the message "Toner replenishment in
progress." may appear and copying will stop even though toner remains. The machine will feed toner for about
2 minutes. When the START indicator lights up, press the [START] key (
) to resume copying.
• When the toner cartridge replacement required icon ( ) appears in the display, little toner remains and thus
copies may be faint.
Note
• After removing the toner cartridge, do not
shake it or tap it. Doing so may cause
toner to leak from the cartridge.
• Put the old cartridge immediately in the
bag contained in the box of the new
cartridge.
• Do not throw the toner cartridge
into a fire. Toner may fly and cause
burns.
• Store toner cartridges out of the
reach of small children.
• Do not hold the cartridge by the shutter. It
may fall. Grasp the hand grip when
holding the cartridge.
• Be sure to shake the cartridge only before
the tape is removed.
Toner cartridge
lock release lever
Caution
Warning
Shutter
4 or 5 times
Caution
• Even after a new toner cartridge is
installed, the toner cartridge replacement
required indicator (
) may still appear,
indicating that copying cannot be resumed
(toner is not fed sufficiently). In this case,
open and close the front cover. The
machine will feed toner again for about two
minutes and then copying can be resumed.
• Before closing the front cover, make sure
that the toner cartridge is correctly
installed.
• When closing the front cover, gently hold
both ends.
Note