Sharp AR-M162 - Manual (Page 274)

30
HOW TO USE THE NETWORK SCANNER FUNCTION
3 Press the [OK] key.
4 Select the desired threshold value
with the [
] or [ ] key.
The default setting is "128". White becomes stronger
as the displayed value approaches "1". Black becomes
stronger when the displayed value approaches "254".
5 Press the [OK] key.
The set value is stored and you
return to the base screen.
ENABLING SCANNING MARGINS (VOID AREA)
When this function is enabled, margins (void areas that are not scanned) are created around the edges of the machine's
maximum scanning area.
Select scan mode, place the original (steps 1 to 3 on
page 20 ), and then follow the procedure below.
The factory default setting for the void area is "ON" (enabled).
If you need to change the void area setting, follow these steps.
Void area: 7/64" (2.5 mm) from the top and bottom edges
1/8" (3.0 mm) from the left and right edges
1 Press the [SPECIAL FUNCTION] key in
scan mode.
Perform this operation from the
base screen of scan mode.
When the [SPECIAL
FUNCTION] key is pressed, the
special function menu appears.
(To select scan mode, see step
1 on
page 20 .)
2 Select "VOID AREA" with the [ ] or
[ ] key.
3 Press the [OK] key.
4 Select "ON" or "OFF" with the [ ] or
[ ] key.
5 Press the [OK] key.
The setting is stored and you
return to the base screen.
GHI
OK BACK
B/W THRESHOLD
128
(1~254)
OK
DUPLEX
SPECIAL FUNCTION
ACC.
DUPLEX SCAN
DUPLEX SCAN
GH
PQR
DUPLEX
SPECIAL FUNCTION
DUPLEX SCAN
SPECIAL FUNCTION
B/W THRESHOLD
LIGHT SOURCE
VOID AREA
PAPER SIZE SET
GHI
OK BACK
VOID AREA
ON
OFF
OK