Sharp AR-M162 - Manual (Page 62)

60
COPY FUNCTIONS
ONE-SIDED COPIES OF TWO-SIDED ORIGINALS
(ONLY WHEN USING THE RSPF)
• Paper sizes that can be used are 11" x 17", 8-1/2" x 14", 8-1/2" x 13", 8-1/2" x 11", 8-1/2" x 11"R, A3, B4, A4, A4R,
B5, B5R and A5.
• Automatic two-sided copying is not possible when the bypass tray is used.
• This copy function cannot be used in combination with dual page copy.
1 Make sure that an original does not
remain on the document glass, and
then adjust the original guides to the
width of your originals and place the
originals face up in the document
feeder tray.
2
Press the [DUPLEX] key.
The duplex mode selection
screen appears.
3 Select "2 to 1" with the [ ] or [ ] key,
or with the [DUPLEX] key.
4 If you wish to have the orientation of
the back image be opposite the
orientation of the front image, set
"BINDING CHANGE" to "ON" with the
[
] or [ ] key.
If the copies are to be bound at the top, reversing the
orientations of the front and back images will result in a
uniform orientation when the bound copies are viewed (note
that this may depend on the orientation of the originals).
5 Press the [OK] key.
You will return to the base
screen.
6 Set the number of copies and press
the [START] key (
).
To stop copying in the middle of
a run, press the [C] key.
O % OUTPUT DUPLEX
SPECIAL FUNCTI
MAT ORIGINAL SIZE DUPLEX SCAN
DUPLEX SCAN ORIGINAL SIZE CAST
COPY MODE
1 to 1
1 to 2
2 to 2
GH
PQR
DUPLEX
SPECIAL FUNCTION
DUPLEX SCAN
COPY MODE
1 to 2
2 to 2
2 to 1
BINDING CHANGE OFF
Do not touch an original (A) that is on the
reversing tray. Doing so may cause a misfeed.
COPY MODE
1 to 2
2 to 2
2 to 1
BINDING CHANGE ON
GHI
OK BACK
WXYZ
Note
(A)