Sharp AR-M162 - Manual (Page 70)

68
CREATING MARGINS WHEN COPYING
(Margin shift)
The margin shift function shifts the image to create a margin at the edge of the paper. By default the function creates
a 1/2" (10 mm) margin at the left edge of the paper.
• You can select whether to create a margin at the top edge or at the left edge of the paper.
• Five selections are available for the margin width: 0", 1/4", 1/2", 3/4", 1" (0 mm, 5 mm, 10 mm, 15 mm, 20 mm).
(The default setting is 1/2" (10 mm).)
• When making two-sided copies, a margin is created at the selected edge on the front side of the paper, and a
margin is created on the back side of the paper.
• Margin shift cannot be used in combination with 2 in 1 / 4 in 1 copy (page 66).
• Margin shift cannot be used in combination with card shot (page 71).
• When margin shift is selected, rotating copying will not operate even if the condition for rotate copying is met.
• The default margin shift setting can be changed in the key operator programs. (See the "Key operator's guide".)
1 Place the original in the document
feeder tray or on the document glass.
• When a left-edge margin is
selected and you are copying
from the document feeder
tray, place the original face up
so that the margin edge is to
the left.
When a left-edge margin is selected and you are
copying from the document glass, set the original
face down so that the margin edge is to the right.
• When a top-edge margin is selected, place the
original with the margin edge toward the rear of the
document feeder tray or the document glass.
2 Press the [SPECIAL FUNCTION] key.
The function screen appears with "SPECIAL MODES"
selected.
3 Press the [OK] key.
The special modes screen will appear with "MARGIN
SHIFT" selected.
4 Press the [OK] key.
The settings for margin
shift will appear.
5 Select the margin location with the
[
] or [ ] key and select the width
with the [ ] or [ ] key.
• Select "DOWN" or "RIGHT"
for the margin location.
• If you select 0" (0 mm), the
printed result is the same as
when "OFF" is selected.
6
Press the [OK] key.
You will return to the base
screen.
7
Select other copy settings as needed
and press the [START] key (
).
To turn off the margin shift
function, select the margin shift
feature again and select "OFF".
A A A A
Original Copy
Margin (top)
Original Copy
Margin (left edge)
DUPLEX
SPECIAL FUNCTION
ACC.
DUPLEX SCAN
DUPLEX SCAN
SPECIAL FUNCTION
SPECIAL MODES
ORIG. SIZE ENTER
PAPER SIZE SET
DISPLAY CONTRAST
GHI
OK BACK
SPECIAL MODES
MARGIN SHIFT
ERASE
DUAL PAGE COPY
[OK]:ADJUST
OK MARGIN SHIFT
OFF
DOWN
RIGHT
1/2 inch (0~1)
GH
PQR
DUPLEX
SPECIAL FUNCTION
DUPLEX SCAN
OK
WXYZ
@.-_
READ-END