Sharp AR-M162 - Manual (Page 19)

17
1
TURNING THE POWER ON AND OFF
The power switch is located on the left side of the machine.
POWER ON
Turn the power switch to the "ON" position
• It will take about 45 seconds
for the machine to warm up.
• When the power switch is
turned to the "ON" position,
the message "System check."
will appear in the message
display and warm-up will start.
Once the copier has finished warming up, the
message display will change to "Ready to copy." and
the START indicator will light up to indicate that
copying is possible. Copy settings can be selected
during warm-up.
• If auditing mode has been enabled (see the "Key
operator's guide"), the message "Enter your account
number." will appear after warming up. Once a valid
account number has been entered, the message
display will change to "Ready to copy." and copying
will be possible.
POWER OFF
Make sure that the machine is not in operation
and then turn the power switch to the "OFF"
position.
If the power switch is turned off
while the machine is in
operation, a misfeed may occur
and the job that was in progress
will be canceled.
Power save modes
The machine has two power save modes to reduce power consumption, thereby helping to reduce environmental
pollution and conserve resources.
Preheat mode
This function automatically switches the machine to a low power consumption state if the duration of time set in the
key operator programs elapses without the machine being used when the power is on. In preheat mode the display
turns off. Normal operation automatically resumes when a key on the operation panel is pressed, an original is
placed, or a print job or fax is received.
Auto power shut-off mode
This function automatically switches the machine to a state that consumes even less power than preheat mode if the
duration of time set in the key operator programs elapses without the machine being used when the power is on.
During auto power shut-off, only the mode key indicators are lit. To restore the machine to normal operation, press
any one of the mode keys. Normal operation also resumes automatically when a print job or fax is received or
scanning is begun from a computer. While auto power shut-off is in effect, pressing a key other than a mode key will
have no effect.
• If the fax option is installed, be sure to keep the power turned on.
Faxes cannot be received when the power is turned off.
• The machine is set at the factory to return all settings to the default settings one minute after a copy job is
finished (auto clear function). When the settings return to the default settings, any functions that were selected
are canceled. The auto clear time can be changed in the key operator programs. (See the "Key operator's
guide".)
The preheat mode activation time and the "Auto power shut-off timer" can be changed in the key operator
programs. (See the "Key operator's guide".)
Note
Note