Sharp AR-M162 - Manual (Page 201)

72
PROGRAMMING
STORING, EDITING AND DELETING PROGRAMS
You can store a transmission method*, cover sheet/message, transmission settings, dual pages, and/or
resolution/exposure settings in a program. This will allow you to use the settings for a transmission by means of a
simple operation (see "USING A PROGRAM" on page 45).
* Transmission methods: normal transmission, broadcast transmission, polling, serial polling, F-code transmission,
F-code polling
To store a program, follow steps 1 through 6 on pages 62
to 63 and then follow the steps below.
1 Select "ENTRY" with the [ ] or [ ] key.
2 Press the [OK] key.
3
Select "PROGRAM" with the [ ] or
[ ] key.
4 Press the [OK] key.
5 Select "ENTER", "CHANGE", or
"DELETE" with the [
] or [ ] key.
• To store a program, select "ENTER" and press the
[OK] key. Continue from step 6 of "STORING A
PROGRAM".
• To edit a program, select "CHANGE" and press the
[OK] key. Next, follow the steps in "EDITING
PROGRAMS" on page 73.
• To delete a program, select "DELETE" and press the
[OK] key. Next, follow the steps in "DELETING
PROGRAMS" on page 73.
[STORING A PROGRAM]
6 Select the program that you wish to
store with the [
] or [ ] key.
If you select a program that has already been stored, a
message appears. Select a program that has not been
stored, or clear the program (page 73) and then select
it.
7 Press the [OK] key.
8 Enter a program name (see
"ENTERING CHARACTERS" on page
82).
Up to 36 characters can be stored for the name of the
program. A program name must be entered.
9 Press the [OK] key.
An original size setting, screen setting, and timer transmission setting cannot be stored in a program. Note
GH
PQR
2-SIDED
COPY
SPECIAL FUNCTION
SPECIAL FUNCTION
ORIGINAL STORE
PRINT
ENTRY
GHI
OK BACK
ENTRY
DIAL
PROGRAM
SUB ADD SETTING
PROGRAM
ENTER
CHANGE
DELETE
PROGRAM
XXXXXX
— — — — — —
— — — — — —
26 27 28 29 30
31 32 33 34 35
36 37 38 39 40
A B C D E
F G H I J
K L M N O
PROGRAM NAME
ABCD
E
ABC