Sharp AR-M162 - Manual (Page 337)

11
INSTALLING THE SOFTWARE (THAT ACCOMPANIES THE MACHINE)
1
10 The files required for installation of
the MFP driver are copied (if "MFP
Driver" was selected in Step 8).
Follow the on-screen instructions.
When you are asked how the printer is
connected, select [Connected to this computer]
and click the [Next] button.
When "The installation of the SHARP software is
complete" appears, click the [OK] button.
11 If you wish to install Button Manager
or Sharpdesk, click the [Utility
Software] button in step 8.
12 Click the [Button Manager] or
[Sharpdesk] button.
To view information on the software, click the
[Display Readme] button.
Follow the on-screen instructions.
13 Click the [Close] button.
14 Connect the machine to your
computer with the interface cable.
(Page 44)
• If you are using a USB cable, make sure the
machine power is turned on and then connect
the cable.
• If you are using a parallel cable, turn off both the
machine power and the computer power and then
connect the cable. Turn the machine power on
first and then turn on your computer. The machine
is found and a plug and play window appears. If
you are using a parallel cable, go to step 16.
15 Installation of the scanner driver
begins. (only when using a USB cable).
"SHARP AR-XXXX" will appear in the "Found New
Hardware Wizard" dialog box. Select [Install the
software automatically (Recommended)], click the
[Next] button, and follow the on-screen instructions.
16
Installation of the printer driver
begins.
"SHARP AR-XXXX" will appear in the "Found New
Hardware Wizard" dialog box. Select [Install the
software automatically (Recommended)], click the
[Next] button, and follow the on-screen instructions.
This completes the installation.
• If you installed the MFP Driver, see "CONFIGURING
THE PRINTER DRIVER" (page 42) to configure the
printer driver settings.
• If you installed Button Manager, see "SETTING UP
BUTTON MANAGER" (page 18) to set up Button
Manager.
If a warning message regarding the
Windows logo test appears while the MFP
driver files are being copied (the warning
message may appear several times), be
sure to click the [Continue Anyway] button.
• If you are using a parallel cable, do not
select "Button Manager". This feature is
not supported when a parallel cable is
used.
• When a message appears prompting you
to connect the USB cable, click the [OK]
button. For the software that can be
installed, see "INSTALLATION
ENVIRONMENT AND USEABLE
SOFTWARE" (page 7).
After the installation, a message prompting
you to restart your computer may appear. In
this case, click the [Yes] button to restart
your computer.
Caution
Note
Note
If the following message appears on
your computer screen, close it.
• A window regarding "HI-SPEED USB
Device" will then appear. Close the window.
• This message appears when the machine's
USB mode is not set to "Hi-Speed" mode.
For information on switching the USB 2.0
mode, see the "Key operator's guide".
If a warning window appears regarding the
"Windows logo test", be sure to click the
[Continue Anyway] button.
If a warning window appears regarding the
"Windows logo test", be sure to click the
[Continue Anyway] button.
If the dual function board is installed, the
"AR-XXXX (EB)" printer driver and scanner
driver will be installed.
Caution
Caution
Caution
Note