Sharp AR-M162 - Manual (Page 31)

29
2
REMOVING MISFEEDS
When a misfeed occurs during copying, the message " Clear paper path." and the location of the misfeed will appear.
Check the location and remove the misfeed.
First check the misfeed location.
* The illustration shows misfeed locations in the AR-M207 (when the RSPF is installed).
ORIGINAL MISFEED IN THE SPF
If an original misfeeds in the SPF, follow the steps below to remove the misfed original.
Check locations A, B, and C in the diagram at left to
remove the original.
1 Removing original misfeeds from
each location.
• Check location A
Open the feeding roller cover
and gently remove the misfed
original from the document
feeder tray. Close the feeding
roller cover.
• Check location B
Open the SPF and rotate the
two release rollers in the
direction of the arrow to feed the
original out.
If the misfed original is small
(such as a 5-1/2" x 8-1/2" (A5)
original), or if the misfeed
occurred in the reversing tray,
open the right side cover and
gently remove the original.
Close the right side cover.
• Check location C
Carefully remove the misfed
original from the exit area.
[When using the RSPF:]
If the misfed original cannot be
easily removed from the exit
area, open the moveable part of
the document feeder tray,
remove the reversing tray, and
then remove the original.
The paper may tear when you remove a misfeed. In this event, be sure to remove all torn pieces of paper from
the machine, taking care not to touch the photoconductive drum (the green part). Any scratches or damage to
the surface of the drum will cause dirty copies.
Note
(Page 31)
(See below)
(Page 31)
(Page 30)
(Page 34)
(Page 33)
(Page 34)
(Page 34) (Page 34)
(Page 34)
Misfeed locations in the optional
2 x 250-sheet paper feed unit
(Page 34)
Feeding roller cover
Release rollers
Right side cover
After removing a misfed original from the exit area,
be sure to replace the reversing tray and moveable
part of the document feeder tray.
Reversing tray