Sharp AR-M162 - Manual (Page 169)

40
ADVANCED TRANSMISSION METHODS
7 Select "1 TIME" or "REPEAT" with the
[
] or [ ] key.
If you select "1 TIME", the document data is
automatically cleared from memory after your machine
is polled once. If you select "REPEAT", the document
data in memory can be used repeatedly.
If you selected "ADD" or "CHANGE" in step 6, the
transmission settings selected when the previous
document was scanned into the Public Box will be
replaced by the settings that you will select this time.
8 Press the [OK] key.
9 Press the [START] key ( ).
• Scanning begins.
• If you are scanning from the
document glass and have
another page to scan, change
pages and press the [START]
key (
). Repeat until all
pages have been scanned
and then press the
key.
10 Make sure that the reception mode is
set to auto reception.
Transmission begins when the other machine
calls and polls your machine.
Printing documents in the Public Box
To check the document that is stored in the public box, follow these steps to print it out.
1 Follow steps 2 to 6 of "Scanning a
document into polling memory (the
Public Box)" (page 39) and then follow
the steps below.
2 Select "PRINT" with the [ ] or [ ]
key.
3 Press the [OK] key.
Printing begins automatically.
SELECT SENDING
1 TIME
REPEAT
OK
To cancel scanning
To cancel scanning of a document while
scanning is in progress, press the [C] key.
To erase the documents in the Public Box,
follow the procedure in "Deleting documents
from the Public Box" (page 41).
WXYZ
@.-_
READ-END
Note
GH
PQR
2-SIDED
COPY
SPECIAL FUNCTION
ORIGINAL
ADD
CHANGE
DELETE
PRINT
GHI
OK BACK