Sharp AR-M162 - Manual (Page 317)

33
KEY OPERATOR PROGRAMS
5
SPECIAL SETTINGS
IP address settings
This program is used to set the "IP ADDRESS", "SUBNETMASK", and "DEFAULT GATEWAY". The following
screen appears when this program is selected.
1 Enter the IP address, subnet mask,
and default gateway.
2 When you have completed all
settings, press the [OK] key.
The settings will be saved.
3 Turn off the machine power, wait for a
few seconds, and then turn on the
power again.
The new settings will take effect after the power is
turned on.
IP ADDRESS SETT-
INGS
IP ADDRESS
0 0 0 0
[ ][ ] keys
These move the cursor up and
down to select "IP ADDRESS",
"SUBNETMASK", and
"DEFAULT GATEWAY".
[ ][ ] keys
These move the cursor left
and right.
Numeric keys
These are used to enter
numbers.
[C] key ( ) Use this to cancel an entry.
[BACK] key
This cancels an entry and
returns you to the previous
screen.
[CA] key ( )
This cancels the setting and
returns the display to the
base screen of the mode that
was in effect before the key
operator programs were
entered.
[SPECIAL
FUNCTION] key
This cancels the setting and
returns the display to the
base screen of the mode that
was in effect before the key
operator programs were
entered.