Sharp AR-M162 - Manual (Page 24)

22
BEFORE USING THE PRODUCT
DISABLING (ENABLING) AUTO TRAY SWITCHING
When auto tray switching is enabled and paper runs out during copying or printing, the job will continue using paper
from a different tray if that tray has the same size of paper in the same orientation. (This function does not operate
when using the bypass tray or when a fax is being printed.) This function has been enabled at the factory. If you
prefer to disable the function, follow the steps below.
1 Press the [SPECIAL FUNCTION] key.
The special function
screen will appear.
The above screen appears in copy mode.
2 Select "PAPER SIZE SET" with the [ ]
or [ ] key.
3 Press the [OK] key.
The paper size setting
screen will appear.
4 Press the [ ] key repeatedly until
"AUTO TRAY SWITCHING" appears.
Move the cursor to the lowest tray and then press the
[
] key again. The above screen will appear.
5 Press the [OK] key.
When a checkmark does not appear in the checkbox,
the auto tray switching function will not operate.
6 Press the [ ] key.
You will return to the
paper size setting screen.
To re-enable auto tray switching, press the [OK] key in
the screen of step 5 so that a checkmark appears.
DUPLEX
SPECIAL FUNCTION
ACC.
DUPLEX SCAN
DUPLEX SCAN
SPECIAL FUNCTION
SPECIAL MODES
ORIG. SIZE ENTER
PAPER SIZE SET
DISPLAY CONTRAST
GH
PQR
DUPLEX
SPECIAL FUNCTION
DUPLEX SCAN
SPECIAL FUNCTION
SPECIAL MODES
ORIG. SIZE ENTER
PAPER SIZE SET
DISPLAY CONTRAST
GHI
OK BACK
PAPER SIZE SET
8 x11R 11x17
11x17 8 x14
8 x13
8 x11
1
2
1
2
1
2
1
2
PAPER SIZE SET
AUTO TRAY
SWITCHING
OK PAPER SIZE SET
AUTO TRAY
SWITCHING
PAPER SIZE SET
8 x11R 11x17
11x17 8 x14
8 x13
8 x11
1
2
1
2
1
2
1
2