ADC AVIDIA SWD4573I1 User Manual
Page 192
Configuring PVPCs
166
Avidia System Configuration and Management User Manual
Adding a Backup PVPC to an Existing Cell Channel Card PVPC
You can configure backup PVPCs at the same time you configure a primary PVPC, as described
in the previous section. However, you can also add a backup PVPC to an existing primary PVPC
configuration.
From the
::
pvpc
=>
prompt, type the backup command in the following format:
backup <index> [<lport> <vpi>]
Parameters
<index>
The PVPC Table row index number of the primary PVPC for which you want to configure
a backup PVPC.
[<lport> <vpi>]
(Optional) Configures a backup PVPC using the specified destination port (format
slot.port), and VPI. Use the line card port (format slot.port) for the destination port. The
VPI value can either be the same value as the primary PVPC or a different value. Omitting
this parameter automatically establishes a backup PVPC on the other line card using the
same VPI as the primary PVPC.
Examples
::pvpc=> backup 3 12.1 25
::pvpc=> backup 3
Restoring Service from a Backup PVPC to a Primary Cell Channel Card
PVPC
After traffic has switched from a primary PVPC to the configured backup PVPC, you can
manually switch it back.
1
From the
::pvpc=>
prompt, type
show
to display the configured cell channel card
PVPCs.
2
Note the PVPC table index number of the PVPC for which you want to restore service.
3
From the
::pvpc=>
prompt, type the restore command in the following format:
restore <index>