ADC AVIDIA SWD4573I1 - Manual (Page 483)

Chapter 22: Configuring ATM Virtual Circuits
Avidia System Configuration and Management User Manual 457
8 In the Destination Retry Limit box, type a retry limit value between 0 and 65535.
The retry limit is the maximum number of allowable unsuccessful call setup attempts.
9 In the Tx Idx box, type the traffic descriptor profile index to assign to transmitted traffic.
To view the ATM Traffic Descriptor Configuration Table , click Browse .
10 In the Rx Idx box, type the traffic descriptor profile index to assign to received traffic.
To view the ATM Traffic Descriptor Configuration Table , click Browse .
11 Click Set to save the SPVC configuration, otherwise click Cancel .
Deleting SPVCs
1 In the SPVC Configuration window, locate the table row that contains the entry you want to
delete.
Click and if necessary to view the entire table. displays the beginning of the
table. displays the next page of the table.
2 Click next to the row that contains the information you want to delete.
A confirmation dialog displays.
3 Do one of the following:
• Click Delete to delete the selected table entry, then in the confirmation dialog click Back
to return to the SPVC Configuration window.
• Click Cancel to return to the SPVC Configuration window without deleting the table entry.
C
ONFIGURING
ATM R
OUTING
If an Avidia system has two line cards installed, you can configure IISP (Interim Inter-Switch
Signaling Protocol) static routes to provide line card redundancy. IISP enables static routing of
signaling messages between clustered AVIDIA systems. When a line card fails, the system uses
the IISP static route configuration to reroute SPVCs to another line card.
You configure ATM Routing from the ATM Routing Table window. Do one of the following to
open the ATM Routing Table window:
• In the Site Map Navigation window, click Routing Table .
• In the Tree Navigation window, click Configuration Management , ATM, Routing Table .