Hale FoamLogix 6.5 - Manual (Page 106)

❑ Start-up Check List
106 FoamLogix 3.3 / 5.0 / 6.5 Installer / Operations Manual
p/n: 029-0021-68-0
System Operation Check
After initial system power-up, low tank level sensor operation, foam pump
operation and flow sensor calibration must be checked.
CAUTION !
WATER IS USED AT THE SYSTEM INSTALLER FACILITY TO VERIFY LOW
TANK LEVEL SENSOR OPERATION AND FOAM PUMP OPERATION AS THE
END USER SPECIFIED FOAM CONCENTRATES MAY NOT BE READILY
AVAILABLE.
DO NOT PUMP WATER WITH THE HALE FOAMLOGIX FOAM PUMP FOR
MORE THAN ONE MINUTE PER FOAM TANK.
DO NOT ATTEMPT TO CALIBRATE FOAM PUMP FEEDBACK SENSOR WITH
OTHER THAN END USER SPECIFIED FOAM CONCENTRATE.
MAKE SURE THE BYPASS VALVE IS IN THE BYPASS POSITION WHEN
PUMPING WATER WITH THE FOAM PUMP.
1. On initial power-up with the foam tanks empty, the display on the control
unit alternates between O and Lo A indicating the foam tank is empty.
Fill foam concentrate tank A with water. The Lo A indication should dis-
appear from the display, indicating the low tank level sensor in Tank A is
operating properly.
2. If the system is equipped with an ADT or MDT II, move the selector to
the TANK B position and observe the display. The display should alter-
nate between O and Lo B indicating this foam tank is empty.
Fill foam concentrate tank B with water. The Lo B indication should dis-
appear from the display, indicating the low tank level sensor in Tank B is
operating properly.
3. If the system is equipped with an ADT, MDT II or MST, place the selector
in the FLUSH position. FLUSH and O should alternate on the display.
4. With proper operation verified, place the selector to TANK A position (or
FOAM TANK position on MST).
Note: The bypass valve pull handle on the ADT has two detents that the valve
must pass through to be fully open. Make sure the bypass valve is fully opened
before attempting to operate foam pump.