Hale FoamLogix 6.5 - Manual (Page 68)

❑ Installer Installation
68 FoamLogix 3.3 / 5.0 / 6.5 Installer / Operations Manual
p/n: 029-0021-68-0
2. Mark 4 holes to mount the foam strainer bracket. Drill tapped holes for
1/4”-20 UNC screws (#7 drill for ¼-20 UNC tap)...or...drill clearance
holes for 9/32” (7 mm) for 1/4”-20 UNC screws. (See Figure 3-15: “In-
Line Strainer Mounting Bracket Layout.”)
3. Secure the bracket
and strainer/valve
assembly to the
apparatus.
4. Select the appropri-
ate fittings from the
bag attached to the
strainer assembly.
Two of each fitting are
included with the
strainer assembly.
For fitting selection vs.
type of foam concen-
trate see Figure 3-14:
“In-Line Strainer/Valve
Installation.”
5. Coat all fitting threads
with Permatex #80724
(or equal) plastic pipe thread sealant. Install the fittings into the strainer/
valve assembly ends and tighten.
6. Install the clear plastic hose from the foam tank outlet to the inlet of the
strainer/valve assembly. (See Figure 3-14: “In-Line Strainer/Valve
Installation,” on page 67.) Wet the ends of the hose and fittings to make
the installation easier.
CAUTION!
MAKE SURE THE FOAM TANK AND FOAM CONCENTRATE SUCTION HOSES
ARE CLEAN BEFORE MAKING FINAL CONNECTION TO FOAM PUMP. IF
NECESSARY FLUSH THE TANK AND HOSES PRIOR TO MAKING THE
CONNECTION.
7. Install the clear plastic hose from the in-line strainer/valve assembly out-
let to the inlet of the Hale MDT II, Hale MST, foam concentrate pump, or
the correct fitting on Hale ADT.
Figure 3-15: In-Line Strainer Mounting Bracket
Layout