Figure 3-17: fs strainer mounting dimensions – Hale FoamLogix 6.5 User Manual
Page 70
❑ Installer Installation
70
FoamLogix 3.3 / 5.0 / 6.5 Installer / Operations Manual
p/n: 029-0021-68-0
Figure 3-17: FS Strainer Mounting Dimensions
8.
Make sure the strainer is properly oriented. (See Figure 3-16: “FS
Strainer Orientation.”) Apply Loctite #242 Threadlock Compound (or
equal) to the screws, then secure the strainer body and nameplate to
the apparatus. Install the strainer cap.
9.
Install the clear plastic hose from the foam tank outlet to the inlet of the
strainer. (See Figure 3-14: “In-Line Strainer/Valve Installation,” on page
67.) Wet the ends of the hose and fittings to make the installation
easier.
CAUTION !
MAKE SURE THE FOAM TANK AND FOAM CONCENTRATE SUCTION HOSES
ARE CLEAN BEFORE MAKING FINAL CONNECTION TO FOAM PUMP. IF
NECESSARY FLUSH TANK AND HOSES PRIOR TO MAKING CONNECTION.
10.
Install the clear plastic hose from the strainer outlet to the inlet of the
Hale FoamLogix foam pump, or the selector valve.