Hale FoamLogix 6.5 - Manual (Page 24)

❑ Introduction
24 FoamLogix 3.3 / 5.0 / 6.5 Installer / Operations Manual
p/n: 029-0021-68-0
6. Determine the low tank level sensors needed.
❑ Side Mount
❑ Bottom Mount
❑ Top Mount Assembly
7. Select the flow sensor, then the mounting weld fitting or saddle clamp
based on discharge pipe size.
8. Select harness length.
❑ 10 feet flow sensor x 15 feet controller
❑ 15 feet flow sensor x 20 feet controller
9. Additional Hale components available to enhance system operation and
ease installation include:
❑ Waterway Check Valves
❑ Manifolds
❑ Flanges
❑ Foam Tanks, etc.
10. Components shown in bold type represent the best value performance
system. All components listed have been engineered and tested with
Hale foam systems to provide optimum system performance. Using the
information provided and the detailed ordering procedures on the option
order form ensures a complete Hale foam system is ordered, thus elimi-
nating delays caused by missing components.
11. System components are shown in the following heading “Hale Foam
System Specifications.”
2.8 HALE FOAM SYSTEM SPECIFICATIONS
(See Figure 2-2: “Foam Pump Installation Envelope Dimensions,” on page
25.) Also see Figure 2-3: “Foam Pump Installation Envelope Dimensions,
ADT Option Only” on page 26.
Foam Pump ....................................... Rotary Gear Positive Displacement
Rated Foam Concentrate Output
Model 3.3 ......................................................................3.3 GPM (13 LPM)
Model 5.0 ......................................................................5.0 GPM (19 LPM)