Hale FoamLogix 6.5 - Manual (Page 47)

47 FoamLogix 3.3 / 5.0 / 6.5 Installer / Operations Manual
p/n: 029-0021-68-0
Ins ta lle r Ins ta lla tion
❑
3 Installation
Carefully review the procedures that follow to ensure the system is properly
designed. This section lists components that have been tested with Hale Foam-
Logix and provide the best system performance. Using the recommended materi-
als and specified parts ensures a virtually maintenance free installation.
Differences in apparatus plumbing and foam system configuration make it impracti-
cal to show exactly how the Hale FoamLogix 3.3, 5.0 or 6.5 system is installed on a
particular apparatus. The information contained in this section applies to most situ-
ations and should be used when designing and installing a Hale FoamLogix 3.3,
5.0 or 6.5 system. System plumbing and electrical diagrams are provided to assist
with installation.
Before proceeding with system installation, carefully review the procedures that fol-
low to ensure the system is properly designed.
The Hale FoamLogix system is supplied with six major components that must be
located on the apparatus.
❑ Foam pump and motor assembly
❑ Control unit
❑ In-Line foam strainer/valve assembly
❑ Instruction/system diagram placard
❑ Flow Sensor
❑ Check valve injector fitting
Notes: The flow sensor and check valve injector fitting may be pre-mounted, if a
manifold or pre-configured package is ordered.
Optional components that require mounting on the apparatus include:
❑ ADT operating switch and indicator lights
❑ Flanged elbows
❑ Foam tank(s)
❑ FS-15 or FS-25 panel mounted foam strainers
❑ Manual “dual” tank (MDT II) selector valve
❑ Manual “single” tank (MST) selector valve
❑ Mini Manifold
❑ Remote activation switch