Hale FoamLogix 6.5 - Manual (Page 14)

❑ Safety Precautions
14 FoamLogix 3.3 / 5.0 / 6.5 Installer / Operations Manual
p/n: 029-0021-68-0
NOTICE !
NOTICE – Practices which could result in damage to the apparatus or other
property.
1.2 GUIDELINES
READ ALL INSTRUCTIONS THOROUGHLY BEFORE
BEGINNING ANY INSTALLATION OR OPERATION PROCESS.
❑ Installation should be performed by a trained and qualified installer, or
your authorized Hale Products Service Representative.
❑ Be sure the installer has sufficient knowledge, experience and the proper
tools before attempting any installation.
❑ Make sure proper personal protective equipment is used when operating
or servicing the apparatus.
❑ A foam tank low level sensor must be utilized to protect the Hale foam
proportioner from dry running. Failure to use a low level sensor with the
Hale Foam System voids warranty.
❑ DO NOT permanently remove or alter any guard or insulating devices, or
attempt to operate the system when these guards are removed.
Make sure all access/service panels and covers are installed, closed and
latched tight, where applicable.
❑ DO NOT remove or alter any hydraulic or pneumatic connections, electri-
cal devices, etc. DO NOT tamper with or disconnect safety features or
modify protective guards (such as covers or doors). DO NOT add or
remove structural parts. Doing so voids the warranty.
Any of the above could affect system capacity and/or safe operation of
the system and is a serious safety violation which could cause personal
injury, could weaken the construction of the system or could affect safe
operation of the FoamLogix Proportioning System.
WARNING !
NO MODIFICATIONS OR ADDITIONS MAY BE MADE TO THE FOAMLOGIX
PROPORTIONING SYSTEM WITHOUT PRIOR WRITTEN PERMISSION FROM:
Hale Products, Incorporated
Fire Suppression Division
700 Spring Mill Avenue