Hale FoamLogix 6.5 - Manual (Page 23)

23 FoamLogix 3.3 / 5.0 / 6.5 Installer / Operations Manual
p/n: 029-0021-68-0
Intr oduction
❑
2.7 ORDERING INFORMATION
Use the current Hale FoamLogix Foam System Price List and Order Form to
help ensure a complete matched system is provided to the end user.
Use the following procedure when ordering a Hale FoamLogix Foam Sys-
tem. Follow all steps to ensure that a complete system is ordered:
1. Check Hale Foam system product information update (Bulletin #961) for
the latest information and advice for foam system selection. A copy of
Bulletin #961 is located at the back of this manual.
2. Determine the type of foam concentrate being used in the system and
ensure system compatibility by referring to the Hale Foam Concentrate
Compatibility Chart. Also see Heading “Appendix A: Foam Concentrate
Compatibility” on page 149.
3. Determine the Hale Foam system needed.
❑ Model 6.5 (24VDC motor only)
❑ Model 5.0
❑ Model 3.3
❑ 12 VDC
❑ 24 VDC motor
4. Determine tank selector needed based on the number of foam concen-
trate tanks installed.
❑ ADT........... for dual tank systems
❑ MDT II ....... for dual tank systems (not available for model 6.5)
❑ MST .......... for single tank systems
❑ No Select .. for single tank systems –
System installer/builder must provide flushing water connection to the
foam pump.
5. Determine strainers needed.
❑ In-line Strainer and Valve Assembly
❑ FS 15 Strainer
❑ FS 25 Strainer