Hale FoamLogix 6.5 - Manual (Page 110)

❑ Setup and Calibration
110 FoamLogix 3.3 / 5.0 / 6.5 Installer / Operations Manual
p/n: 029-0021-68-0
Note: Pressing the DISPLAY button (
i
) cycles through the four functions as indi-
cated by the red LED illuminating under each function (FLOW, %, TOTAL FLOW
and TOTAL FOAM).
Priming the Foam Pump
After the foam tank(s) are filled with the proper foam concentrate and the
system is powered up, foam concentrate flow must be checked to verify the
foam pump is primed.
CAUTION !
WHEN OPERATING THE HALE FOAMLOGIX IN SIMULATED FLOW MODE AN
OUTLET FOR THE FOAM CONCENTRATE MUST BE PROVIDED TO PREVENT
EXCESSIVE PRESSURE BUILDUP IN DISCHARGE PIPING OR HOSES.
1. Make sure the bypass valve is in the BYPASS position. Route the bypass
hose into a suitable container to collect the discharged foam concentrate.
Note: If dual foam tank system is used select TANK A. Make sure there is foam
concentrate in both foam tanks.
2. Place the system in simulated flow mode by selecting the FLOW display and
pressing both and buttons simultaneously. (See Figure 4-2: “Simulated
Flow Mode Display.”)
Figure 4-2: Simulated Flow Mode Display