Hale FoamLogix 6.5 - Manual (Page 151)

Ha le Foa m Conc e nt ra te Compa tibilit y C ha rt
❑
151
www.haleproducts.com/products/foam
Reference
The preceding foam concentrates have been tested by Hale Products to
ensure compatibility with Hale FoamLogix models 5.0 and 3.3 Foam Pro-
portioning Systems. These chemicals were run for several hundred hours
over several months to make sure they do not harm the Foam System. This
list is solely intended to assist the end user in selection of foam concen-
trate(s) compatible with a Hale FoamLogix Model 5.0 and 3.3 and is not a
determination of the fire fighting effectiveness of one product over another.
Always consult with NFPA standards, U.L. Listings, Federal, State, and local
regulations pertaining to application and environmental regulations before
selecting a foam concentrate. (Refer to FoamLogix User Manual for addi-
tional information.)
Many fire fighting foam chemical manufacturers have specific instructions
on handling and use of their products including, but not limited to, shelf life,
tank life, and intervals between use. Always follow manufacturer’s instruc-
tions for use.
This Appendix applies to Hale FoamLogix foam pumps built after April 17,
1997. For Hale FoamMaster foam pumps built prior to April 17, 1997, refer
to Bulletin 650, Rev-2.
If a particular foam concentrate you wish to use does not appear on this list,
please contact your Hale representative for information concerning compat-
ibility with Hale FoamLogix Model 5.0 or 3.3 Foam Proportioning Systems.
As further testing is completed, Hale Products Inc. updates this list and
expands capabilities and features to keep the Hale FoamLogix the best sys-
tem available for all fire fighting.
Revised 02/10/2005