Hale FoamLogix 6.5 User Manual
Page 17
Sa fe ty Pre ca utions
❑
17
FoamLogix 3.3 / 5.0 / 6.5 Installer / Operations Manual
p/n: 029-0021-68-0
❑
There are no user serviceable parts inside Hale Foam system electrical/
electronic components.
Opening the distribution box, control unit, foam multiplexing dis-
play unit, etc., voids the warranty.
❑
Use mounting hardware that is compatible with all foam concentrates to
be used in the system. Use washers, lock washers and cap screws
made of brass or 300 series stainless steel.
❑
When making wire splice connections, make sure they are properly insu-
lated and sealed using an adhesive filled heat shrink tubing.
❑
ALWAYS connect the primary positive power lead from the terminal block
to the master switch terminal or the positive (+) battery terminal.
Use a minimum 4 AWG type SGX (SAE J1127) chemical resistant bat-
tery cable and protect with wire loom.
❑
Prevent corrosion of power and ground connections by sealing these
connections with the silicone sealant provided.
❑
Prevent possible short circuit by using the rubber boot provided to insu-
late the primary power connection at the Hale FoamLogix Distribution
Box.