Apple Shake 4 - Manual (Page 296)

296 Chapter 10 Parameter Animation and the Curve Editor
Note: Whenever you turn on an Autokey button, the corresponding parameter’s curve
loads into the Curve Editor.
In the following example, even though the pan and angle parameters are both
animated, the angle parameter is the only one that’s actually displayed in the Curve
Editor.
Controlling Curves Displayed in the Curve Editor
There are several controls that allow you to control the visibility of curves from within
the Curve Editor.
Autoload Controls
Use the Autoload curve viewing controls within the Curve Editor to choose which
parameter curves are automatically loaded into the Curve Editor. There are two options:
• Turn on Current to show all the parameters that are animated within a node that’s
loaded into one of the Parameters tabs, regardless of whether or not the Load Curve
controls are enabled.
• Turn on Selected to show all animated parameters from all nodes that are selected in
the Node View, whether or not any nodes are loaded into one of the Parameters tabs.
Click Current to display
all animated parameters
from the currently
loaded node.
Click Selected to display all animated
parameters from the selected node.