Rockwell Automation 1395 Digital DC Drive FRN 5-10.10/9.30 - Manual (Page 150)

Chapter 6
Installation
6-26
Terminal TB5–6&7 125–300HP 230VAC
250–600HP 460VAC
The 115VAC control voltage enters the drive and is controlled by the
pilot relay (PR). If it is desired to control the Ml coil voltage using
contacts external to the drive (in addition to the pilot relay), the external
contacts must be wired in series with the 115VAC supply voltage before
entering the drive at either TB2-1, TB2-3 or TB5-4 . In most
applications, external contacts are not used, therefore, 115VAC is
supplied directly to TB2 or TB5 as follows:
Terminal TB2-2 1–30HP 230VAC
2–60HP 460VAC
Terminal TB2-4 40–100HP 230VAC
75–200HP 460VAC
Terminal TB5-4 125–300HP 230VAC
250–600HP 460VAC