Rockwell Automation 1395 Digital DC Drive FRN 5-10.10/9.30 - Manual (Page 181)

Chapter 7
Programming Parameters
7-15
Parameter Descriptions This section provides a brief description of the parameters in the Bulletin
1395. The programming terminal for the 1395 is also used for other
products. Parameters not used by the 1395 will appear as follows “NOT
USED, NOT CHANGEABLE”. Information is provided in the
following format:
Parameter Number – Parameter Name [Parameter Name as it appears
on the Programming Terminal].
Internal Units – Definition of per unit numbers used internally by the
Bulletin 1395 Control.
Programming Terminal Units – Scaled engineering units which appear
on the Programming Terminal.
Minimum – Minimum value in engineering units where possible.
Maximum – Maximum value in engineering units where possible.
Default – Initial default in engineering units where possible.
Description – Brief Description of the use and operation of the
parameter.
Parameters (Numerical)
Parameter 10 – SP Output 1 [SP Output 1]
Internal Units :
Programming Terminal units :
Description : This is a fast source from Parameter 840
Parameter 11 – SP Output 2 [SP Output 2]
Internal Units :
Programming Terminal units :
Description : This is a fast source from Parameter 841
Parameter 12 – SP Output 3 [SP Output 3]
Internal Units :
Programming Terminal units :
Description : This is a fast source from Parameter 842
Parameter 13 – SP Output 4 [SP Output 4]
Internal Units :
Programming Terminal units :
Description : This is a fast source from Parameter 843
Parameter 14 – SP Output 5 [SP Output 5]
Internal Units :
Programming Terminal units :
Description : This is a fast source from Parameter 844